Skip to main content

Configuring the new application node and testing replication

After you have added the application node to the replication configuration, propagated changes, and synchronized files, complete the configuration and testing:

  1. Clean up replication configuration .

  2. Log into the new Bravura Security Fabric server’s administration console and set all server-specific variables, including:

    1. Base URL, if a load balancer is not used (Manage the system > Workflow > Email configuration).

    2. Scheduled tasks, if required.

      Ensure that the psupdate task is scheduled to run on only one node in each Bravura Security Fabric instance.

    3. Registry entries.

      In general, registry entries are copied when you run updinst. Verify that any special or custom settings are correct.

    Caution

    Do not copy the database access registry keys, which are located in the <instance>\MSSQL directories. The credentials set here must be able to access the schema that was designated for this new instance.

  3. Test that the backup/restore has completed successfully:

    1. Log into two different Bravura Security Fabric application nodes as the same product administrator.

    2. Ensure that the data on all configuration pages is consistent across all replication nodes.

    3. Make some changes from one node that propagates data to other replication nodes.

    4. Compare the data on all replication nodes again and ensure all changes have been propagated between them.

You can now resume normal operation.

In this section: