Post-installation tasks
Once you have used the setup wizard to configure the installation, click Install to begin copying files to your computer.
The Wizard page appears after the Bravura Security Fabric features have been successfully installed.
Caution
Do not stop the post-installation tasks. The installer is attempting to load connectors from the Connector Pack , language tags, and reports.
If you install the Bravura Security Fabric before a Connector Pack has been installed, a warning appears at this stage that no connectors could be found. It is safe to proceed.
If any of the post-installation tasks produce warnings or errors, click:
Report for details on all post-installation tasks
or
Messages... for details on a specific post-installation task
Otherwise, wait until the status changes to success, then click Finish.
If connectors (agents) were not installed successfully, see Troubleshooting installation in Connector Pack documentation.
Warning
If the server is going to be used for replication, it is important that the server is configured for replication before any modification or configuration of the Bravura Security Fabric software occurs. Replication configuration must be completed first. Refer to Replication and Recovery. This only applies to servers being used for replication.